By Ryan Hogan

Diablo Datalogging Instructions

 

1.First, head to the Diablo download webpage and get the program loaded and installed .   https://www.diablosport.com/downloads/

2.The main screen of the program that pops up when you run it should be all the basic instructions on the screen. After its running, connect the tuner into the OBD-II port and have it set to the main screen. Then use the USB cable and hook it up to your laptop.

3.Then click the "Connect Tool" button. It will take a minute to search for the tuner but it should start up automatically.

4.After the tuner is connected, click the "Live Data" button

5.Next will bring you to the gauge page with a side bar with all the selectable parameters you can monitor. Select the following:
Igntion
Base Spark
Deg
Actual Spark Cyl 1
Deg
Intake
Intake Air Temp Deg
F
Manifold Air Pressure
kPa
Barometric Pressure
in Hg
Injector Pulse Width Cylinder 1
us
Fuel
REQD FUEL CHARGE CYL1
mg/charge (may be labeled as Aircharge)
Miscellaneous
1/1 Short Term ADAP
%
2/1 Short Term ADAP
%
2/1 Long Term ADAP
%
1/1 Long Term ADAP
%
DESIRED FA CYL1
FAR
OPEN LOOP FA
FAR
READ MAP KPA
kPa
P-Ratio MAP/BARO
PRatio
Misfire
KNK LT RETARD
deg
KNK ST RETARD
Deg
Performance
Vehicle Speed
mph
Engine Speed
rpm
Read Engine RPM
rpm
Throttle
Throttle Position Sensor Percent
%
Accelerator Pedal Position
%
Throttle Blade Position
%
This is the best part of the program, it's way easier to find some of the obscure parameters, you don't have to dig around on the handheld looking through all the menus.

6.After you select all the necessary gauges, click on the yellow "Connect" button to start the live feed. When the feed is live you will no longer be able to add new gauges in. You'll have to disconnect it and go through it again.

7.Just hit the red record button and it will start recording until you stop it. After you stop the recording, it will automatically bring up a menu to save the log

8. After it saves just click the yellow "Connect" button and it will refresh the gauges for the next log. Another advantage is the program will keep track of the gauges you have selected and the next time you open it up, they will all be ready to go. That makes it awesome if you have multiple tune revisions and logging sessions. That's the basic rundown, after you save the logs you can just add them as attachments in an email to send to ryan@frptuning.com 

 

Share:

Facebook Tweet